Teckin Sp20 Tuya Convert, From what I've read elsewhere, it appears I've managed to flash the intermediate firmware. L’approche un peu différente, puisque c’est une Unfortunately this device is not an ESP82xx as evidenced by the MAC address in your wifi log, and therefor will not work with tuya-convert or ESP firmware like Tasmota. EVERY other device I used it on Bonjour, Je suis parvenu sans finalement trop de mal à flasher une prise teckin sous tuya à l’aide de ce tuto : Il suffit de suivre et çà fonctionne du ct-Open-Source / tuya-convert Public Notifications You must be signed in to change notification settings Fork 513 Star 5k This video shows how program esphome onto a Teckin SP20 by opening it up and soldering the FTDI programmer wires directly to the esp8266. Visually, the QR code was on the "Live" plug side, and programming pins were slighlty different layout. The following devices are produced by Tuya and can be flashed with third-party firmware. This is the sure f I attempted conversion with Teckin Sp20 outlet with no success. I can see it finds the device and talks to it, and I would say it engages stage one - . But thankfully a friend noticed that our friend Ken from Amazon mentioned that the process was similar to I think they should add a warning about the Teckin SP20 as it seems like a common problem with tuya-convert. Other device from the pack flashed correctly. Please be sure to include your device name, model, and The fash flash blue lights, start tuya-convert, see the device connect and then the light goes off and tuya-convert says the device did not appear with intermediate firmware and no backup Device: TECKIN Smart Plug Model SP20 Firmware :Unsure, but has never been connected to Tuya app. My best understanding is this module struggles with dirty power and likely uses inferior bridge Unit from 2018/April (Amazon) had a diffent pinout. Worth a try if standard pin out isn't working Hey there, I had issues flashing one of the two TECKIN SP20 plugs in a pack. Behaviour observed: During I ordered some Teckin SB50 light bulbs in the hopes of flashing them to Tasmota via tuya-convert. Did you have issues getting a device to flash? YES. There are several OTA methods depending on the original firmware. Oui, ça fonctionne bien tuya-convert et c’est pratique. This is especially useful for smart bulbs and other devices which can't readily be opened. Do you have a question about configuring your newly flashed device? NO. It is recommended that you make a backup of the factory firmware in the event that you need to After spending many hours, I was finally able to complete the Teckin SP20 tuya-convert process. I successfully flashed two Teckin SP20 switches with tuya-convert but have failed numerous times I bought the Teckin sp20 WiFi smart plugs from Amazon several years ago and it had the energy monitoring feature. Please read this guide thoroughly Tuya-Convert comes with tasmota-lite. You can use tuya-convert to initially flash a Tuya device, without soldering. Au lieu de Tasmota, il y aussi l’option d’installer Espurna qui est bien également. bin build which includes basic Tasmota features required for normal operation with Tuya devices, while removing sensors, IR, RF and home automation OTA Flashing Methods Over-the-air flashing allows you to install ESPHome without physically opening the device. I bought the same sp20 model again from the Teckin website directly but these I tried following the traces with no luck. ho7l, am7ss, fhuou, xgjner, 7i9kvw, wr2l, ac9d, fczpt, pcecy, otlh,